One Tire Track instead of Two. How do I do this?

warlord · 04-09-2003, 06:32 PM

How do I make it where it will show only one tire track instead of two. I have a bike model but it shows two tire tracks like if it was a humvee but it needs one track not two.

Zainal · 04-09-2003, 06:41 PM

It's specified in the factionunit.ini entrys just below the units model information. The one used for the Humvee is EXTireTrack.tga. You'll probably find it in textures.big

warlord · 04-09-2003, 06:42 PM

yes i know but that dont fix the 2 track problem i have.

Zainal · 04-09-2003, 07:00 PM

Extract the file, change it to one track and save it as something like EXBikeTrack.dds then put it in Art\Textures

warlord · 04-09-2003, 07:07 PM

How would I go About making it a one track

Zainal · 04-09-2003, 07:20 PM

Open the file. It's kinda small but you'll see two dark patches on either side of a light patch. Crop it so its one dark strip and save.

warlord · 04-09-2003, 07:26 PM

i did that and it still has the 2 treads.

Zainal · 04-09-2003, 07:30 PM

Did you change the entry in factionunit.ini? Did you put the file in Art\Textures? Are you sure it saved properly? Other than that I don't know although it might have something to do with the locomotor.

warlord · 04-09-2003, 07:32 PM

yes yes and yes. I have looked at the locomotor and i dont think its in there but that is what i can tell.

Blaine_the_God · 04-09-2003, 07:45 PM

It might be the fact that is is under four_wheels in the locomotor. Just a thought though